Bronco Light Control Mk.1

Parts

1x Project Box

The container of the project.

Link to buy your own

3x Switches

Allows the lights to be turned on or off.

Link to have your own

9x 22-16 AWG Female Spade Connectors

Allows the wire to be connected to the switches

Red Female Spade Connectors for electrical wire.

3 ft 22-16 AWG Wire

Use wire that is no smaller than 22 awg but not bigger than 16 awg so it will fit in the connectors

Link to the wire I used

Tools

Power Drill

Used with a 1/2 spade hole bit. It makes holes in the project box for the switches.

Power Drill

1/2in or 12mm Spade bit

Used with the Power Drill to make holes in the poroject box for the switches.

1/2 Spade Drill bit. To make 1/2 inch hole.

Wire Stripper with crimper

Strips the wire and crimps the wire to the connectors.

Screwdriver

Blue Screwdriver

Opens the project box and closes the project box.

Instructions

#1 Grab the parts and tools

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.

#2 Grab the project box and remove the screws

Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.

#3 Use the spade bit to put 3 holes in the lid. Then one hole on the side

Accordion Content

#4 Take the 3 switches and put them in the holes in the lid

Accordion Content

#5 Take the connectors , wires, and the wire stripper/chimper to combine them

Accordion Content

#6 Put the connectors on the switches

Accordion Content

#7 Pull the wire though the hole on the inside of the project box

Accordion Content

#8 put the top back on

Accordion Content

#9 Connect the lights to the box

Accordion Content

#10 All done

Accordion Content

Parts

Tools

Instructions

Share this:

Like this: