Led DashBoard for Ford Bronco

To install the Led Dashboard I used a 7mm long socket with a coreless racket along with some pry tools.

I started by pulling down the panel above the driver foot well. Revealing the driver side bolt holding the radio / ac control panel on. Then hoping over to the passenger side to pull out the glove box to get to the passenger side bolt holding the radio / ac control panel on.

From there I got the panel under the radio / ac control loose. Then with both hands and great force I pulled the radio/ ac control down and out.

Next I removed the bolt right under the old dash that removing the radio/ ac panel reviled. After that I removed the 3 bolts that were under the passenger side airbag holding the old dash on.

Now that all the bolts holding the old dash were removed. I grabbed a pry tool and from the top of the dash I pried it out. It was attached to the engine start stop switch so I disconnect it from the back. Now that the dash was free, I put it to the side. I removed the engine start stop switch along with its hosing.

Then I put the Engine start stop switch with its hosing into the Led dash. I then reconnected the engine start stop to the Bronco. Then I pushed the led dash into place when the old one was. Then put the bolts back in their places. From there I connected the electrical of the Led dash. Into my accessories system panel. I connected the ground into a switch I had and positive into a positive bus bar. Then I hit the switch and the led dashboard came to life.